D100-20401P Progressive Lubrication Distributor

The metering quantity of each outlet is 0.2mL per cycle. When one or more outlets are closed, the discharge changes in multiples. A metering device with 6-12 outlets can be selected, up to 22 outlets. Lubricant used: Mineral grease below NLGI2.

Description

D100 series metering device is suitable for all progressive centralized lubrication system.

Characteristics
D100 series metering device is plunger type.
It automatically distributes the lubricant from the pump to the connected lubrication points.
The metering quantity of each outlet is 0.2mL per cycle.
When one or more outlets are closed, the metered quantity of each outlet changes in multiples.
A metering device with 6-12 outlets can be selected, up to 22 outlets.
Lubricant used: Mineral grease above −40mm²/s(cS), or grease below NLGI2.

Mounting
Install the metering device at the appropriate place according to the lubrication diagram.
It is recommended that when mounting the metering device, do not allow the outlet to be too close to the installation bottom plate, otherwise it will not be easy to troubleshoot when the system is blocked.
When mounting a metering valve with pointer, it must be ensured that its pointer is easy to observe visually.
When using quick connectors, please pay attention to the following issues:
The inlet of metering device, only quick connector with reinforced buckles and sealing rings can be used.
For high-pressure hoses (Φ8.6×2.3mm), quick connector with reinforced buckles and sealing rings should be used; for plastic hoses (Φ6×1.5mm), quick couplings with oil threaded buckles should be used .
Note: For construction machinery and agricultural machinery, high-pressure hoses should be used for the lubrication line. In this case, both the second-level metering device and the pipe joints at the lubrication point can adopt quick joints with reinforced sealing rings.
Only use the lubrication pipeline designated by our company and meet the specified system pressure requirements.

Ordercode

Mesolube D100 dimensions

Specifications

Metering quantity
Connection outlet
Inlet thread
Max operating pressure
Min operating pressure
Lubricant
Monitor
Material
Max pressure difference at outlet
Operating temperature
0.2mL/cycle
Φ4   Φ6
G1/8
35MPa
2MPa
NLGI 000~2
Indicator pin
aluminum
10MPa
-25°C to 70°C
​Quick & Screw Connector
High pressure zone max pressure
Main distributor inlet & outlet
Low pressure area max pressure
Second-stage distributor outlet
Lubrication point connector​
Quick & Screw Connector
35MPa
Φ8  Φ6
25MPa
Φ6
Φ4
Main-line
Min rupture pressure
Min bending radius
Min temperature
Branch-line
20°C burst pressure
Min bending radius
Mini temperature​
Main-line
60Mpa
35mm
-40℃
Branch-line
50mm
~21MPa
-40℃​

Dimensions

Mesolube D100 dimensions

Applications

Layout of P100 series pump in progressive system